PMR release agent - GRP release agent (water-based mold release wax) Product Description: (1) PMR is a capable Teflon-like layer as thin tough protective film formed on the surface of the mold release agent (2) is A liquid release agent, easy processing, a coating can be repeated several times release; (3) reduce the residual phenomena SM mold, enhance die life. (4) has good heat resistance up to 400 ℃, applicable on any of the products in the FRP; (5) is not transferred to the finished product, easy processing (such as painting, plating, etc.). Use: (1) new mold or die are old should a suitable solvent cleaning, be sure to surface impurities, dirt and other wax clean and dry to dry; (2) coating method: ① the PMR with a clean gauze soaked After the wet, coated on the mold; ② After coating, before PMR yet dry with a dry cloth to evenly coat the surface around; ③ the first time the FDA, the coating must repeat 4-5 times, each time interval of approximately 10-20 minutes, such as a larger die area, each coated with a continuous coating after the last layer should be wiped with a dry cloth after the mold is coated bright, and after an hour standing use; ④ first When used, it may be difficult gelcoat coating, which is good for the sake of releasing effect, can be coated with a small amount of mold release wax, after having to use; when ⑤ if stripping difficulties, then coated PMR 1-2 times, so that Cost savings can be achieved and to ensure the quality of the object. Notes: (1) use, shall be closed bottle, avoiding contact with moisture in the air, reduce the use of results; (2) Keep away from air and power, and avoid prolonged contact with skin; (3) the use by soapy water can (This product is a low activity, low toxicity chemicals should be avoided dip into the eyes, etc.). Notes: (1) This product does not contain Freon, no international environmental issues; (2) This product is not silicon, wax, make the surface smooth and complete FRP products; (3) This product is used FRP mold, the actual tests played more than 50 times, for a metal mold is up to 1500 times; (4) This product has been approved by the US Environmental Protection Agency safety inspection. Specifications: 0.125 gallons / canister, one gallon / large pot (approximately: 1 kg / canister, 6 kg / big pot)